Nissan GTR-R35 WP20 Clutch Kit

XM-GTR-R35-WP20 CLUTCH KIT

Our Nissan GTR R35 WP20 clutch kits are designed to run 1100+whp, having used the same technology as our WP18 clutch kits. All the parts on this kit have been re-designed to accommodate 20 friction plates with 20 steel plates, however, as we have utilised the same technology as our WP18 clutch kit, which uses the same steels and frictions as used in the WP18 kit, we have the ability to supply common plates for our entire range of clutches from our WP18 through to the XWP24 clutch.

**Please note, this kit comes fully assembled and some of the stock parts will be needed to be returned for modification**

It is important to highlight that this kit comes fully assembled and you are fully aware that some of the stock parts will need to be removed from your vehicle and dispatched to our factory for modification.  The supplied stock parts will become an integral part of your new WP20 plate clutch.

GTR R35 WP20 Clutch
Specification

  • One piece billet plate carrier (not welded)
  • Basket A (2,4,6) CNC machined from single billet, no welds, fully heat treated for durability and strength
  • Basket B (1,3,5,R) CNC machined from single billet, no welds, fully heat treated for durability and strength
  • Piston A, CNC machined from single billet, no welds
  • Piston B, CNC machined from single billet, no welds
  • New clip-in pistons seals, designed for low friction, 100% reliable
  • 20 Wide plate frictions, 1.8mm thick, 37% more friction surface area over stock
  • 18 Wide steel plates, 1.3mm thick, heat treated and surface ground
  • 2 Wide steel end plates, 1.6mm thick, heat treated and surface ground
  • CNC machined billet gear drive plate
  • 3 High quality snap rings

    Contact Form

View our video of “How to build our WP18 plate clutch”
Check out our BLOG

Contact US