Nissan GTR-R35 WP18 Clutch Kit

XM-GTR-R35-WP18 CLUTCH KIT

Our Nissan GTR R35 WP18 plate clutch kits are designed to run 900whp+. These have a one piece billet carrier with no welds.
This kit uses our new clip-in piston seal design which has proven to be 100% reliable.  Both pistons A & B are machined out of a single billet with no welds or parts to come undone.
The friction plates are wider giving approximately 37% more friction surface area than stock. The steels are surface ground and heat treated for durability.

All our clutch kits are designed to run stock oil pumps (unmodified) while retaining stock settings.
This kit comes with billet A & B baskets which are fully heat treated for extra strength and durability.

**Please note there are two sizes of piston B, depending on the year of the vehicle, the correct one will need to be fitted**

Specification

  • One piece billet plate carrier (not welded)
  • Billet basket A (2,4,6) CNC machined, fully heat treated for durability and strength
  • Billet basket B (1,3,5,R) CNC machined, fully heat treated for durability and strength
  • Billet piston A, CNC machined
  • Billet piston B, CNC machined from one piece
  • New clip-in pistons seals, designed for low friction, 100% reliable
  • 18 Wide plate frictions, 1.8mm thick, 37% more friction surface area over stock
  • 16 Wide steel plates, 1.3mm thick, heat treated and surface ground
  • 2 Wide steel end plates. 1.75mm thick, heat treated and surface ground

    Contact Form

Contact US